This standard is issued under the fixed designation D ; the number immediately This test method was adopted as a joint ASTM-IP standard in Buy ASTM D Standard Test Method for Dropping Point of Lubricating Grease from SAI Global. ASTM D – D – IP The dropping point is the temperature at which the grease passes from a semisolid to a liquid state under the conditions of test.
|Published (Last):||22 January 2009|
|PDF File Size:||3.4 Mb|
|ePub File Size:||18.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Gold Member Since Its total length is mm and the depth immersed is about 76 mm. However, agreement between producer and consumer as to the adtm method used is advisable. You Might Also Like. The temperature in oil bath is uniform. These indentations are used for supporting the grease cup.
In cases where results differ, there is no known significance. Inquiry will be replied within 24 hours. Room Temperature to C. Its inner diameter is A tube made of heat-resistant glass with rim.
Enter between 20 to 4, characters. The results are considered to have only limited significance with respect to service performance as dropping point is a static test. Rotating speed 60 RPM 8. Link to Active This link will always route to the current Active version of the standard. E566 who viewed this also viewed.
Its total length is mm and the depth immersed is about 76 mm. Once receive your question, the supplier will answer you as soon as possible. Typical questions asked about products Does this product support customization? Other test procedures [ edit ] Equivalent to D and D Dropping point is used in combination with other testable properties to determine the suitability of greases for specific applications and for use in quality control.
Greases containing as thickeners materials other than conventional soaps can, without change in state, separate oil. Send your inquiry directly to this supplier Receiver’s Company Name: The dropping point of a lubricating grease is an indication of the heat resistance of the grease and is the temperature at which it passes from a semi-solid to a liquid state under specific test conditions.
Send Inquiry Have a question? Contact Now Customized Request.
Welcome to visit our factory. For specific hazard statements, see 6.
ASTM D – 17 Standard Test Method for Dropping Point of Lubricating Grease
It adds that the results are not sufficient to assess service performance because dropping point is a static test. Its inner diameter is about 9.
Historical Version s – view previous versions of standard Translated Version s: Views Read Edit View history. Its inner diameter is X China Hangyu Industry Co. Its total length is mm and the depth immersed is about 76 mm.
The height of the cup is about 12 mm. Send your message to this supplier. Once receive your question, the supplier will answer you as asym as possible. Gross Heat Value Apparatus.
The height of the cup is about 12 mm. Packed in Veneer Case. Made of chrome plated brass. Made of chrome plated brass. These indentations are used for supporting the grease cup. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
The temperature in oil bath is uniform. Historical Version s – view previous versions of standard. No other units of measurement are included in this standard. The heating power can be adjusted continuously.
Caution should be taken when handling mercury and mercury containing products.
Lubricating Grease Dropping Point Apparatus for ASTM D566
Semi Auto Cone Penetrometer. Get Latest Price Min. A thermometer is inserted into the cup and held in place so that the thermometer does not touch the grease.